Mudd-Ox VEN22, Руководство пользователя

Страница: 47 / 100

47
Bearings Cont.
Grease Zerk Locations
As outlined under Axle Configurations and Grease Zerk Configurations , there are (4) possible setups for Ven-
geance. Below is a description and reference to accompanying diagram for reference under Greasing Axle Bear-
ings .
1. Standard axles, standard zerks: Figure-16.
2. Standard axles, optional relocated zerks: Figure-18.
3. Optional bearing extension axles, standard zerks: Figure-17.
4. Optional bearing extension axles, optional relocated zerks: Figure-19.
Greasing Axle Bearings - Standard
1. See Accessing the Mudd-Ox to remove all floor boards, lower seats and engine cover.
A. With optional Bearing Extension Kit: See Wheel Removal under Tires/Wheels to gain access to the outer
axle bearings.
B. Without option: You do not have to remove the wheels, although is recommended for those who cannot
safely or comfortably reach the bearings.
2. Locate each bearing as shown in Figure-17, 18.
3. For each bearing, there is a grease zerk on the bearing flange/block itself. Connect the grease gun onto the fit-
ting as shown in Figure-12. Slowly pump grease into the bearing flange. Once it begins to seep out of the flange/
block, immediately stop. Note: It can seep out of either side of the bearing. If the grease is only seeping around
the grease gun tip, the tip is not fully connected to the grease fitting.
4. See Wheel Installation under Tires/Wheels if removed.
5. See Accessing the Mudd-Ox to reinstall any floor boards, seats and engine cover if removed.
Greasing Axle Bearings - Zerk Relocated
1. See Engine Cover Removal under Accessing the Mudd-Ox. Locate the (3) grease zerk relocation blocks. There
are (2) on the outside rear of the Mudd-Ox (Figure-13) and (1) on the right side engine compartment (Figure-14).
2. On each grease block is a row of grease zerks. Connect the grease gun onto the top fitting as shown in Figure-15.
Slowly pump grease into the fitting. Pump approximately 3-5 times.
3. After greasing the top zerk, proceed to the next one down and repeat step #2. Do this until all zerks on all (3)
blocks have been adequately greased.
Figure-13
Outer Blocks
Figure-11
Figure-14
Inner Block
Figure-12
Figure-15
Grease Gun Connected