Muck-Truck MAX Mk II Dumper, Инструкция по эксплуатации, аксессуарам и запчастям для владельца

Страница: 7 / 30

GB – 7
Skip Release Lever
(Figure 8)
Squeeze the skip release lever to release the skip lock.
Release the skip release lever to engage the skip lock.
PRE-START
Park unit on level surface. Check and add fuel if required.
Check that the engine crankcase oil is full using dipstick.
Refer to Engine Manual for detailed instructions.
Fuel Shut-Off Valve
NOTE: Close the fuel shut-off valve before transporting
the unit.
The fuel shut-off valve has two positions:
• Closed Position – Use this position to service,
transport, or store the unit.
• Open Position – Use this position to operate the
unit.
Adding Fuel
1. ALWAYS place unit in open or well-ventilated area.
2. Stop engine and allow to cool.
3. Remove accessory or tilt forward to gain access to
fuel tank.
4. Clean fuel cap and surrounding area to prevent dirt
from entering fuel tank.
5. Remove cap.
NOTE: DO NOT add oil to fuel. DO NOT use gasohol or
gasoline containing alcohol. See Engine Manual for
correct type and grade of fuel.
6. Fill fuel tank to within 1/2 in. (1.2 cm) of bottom of
filler neck with unleaded gasoline.
7. Replace fuel cap and tighten.
8. ALWAYS clean up any spilled fuel.
STARTING UNIT
1. Move the throttle lever into the Choke position by
moving it fully forward.
NOTE: A warm engine requires less choking than a cold
engine.
2. Grasp recoil starter handle and pull rope out slowly
until it engages.
3. Pull rope with a rapid continuous full arm stroke. Let
rope rewind slowly.
NOTE: DO NOT let starter handle snap back against
engine.
4. Repeat steps 2 and 3 until engine starts.
5. Move throttle lever to the rear to disengage the
choke and set engine speed to idle.
6. Allow engine to warm.
7. Set throttle to desired position based on travel
conditions and gear selected.
OPERATION
To Move Forward
1. Select desired speed (1, 2 or 3) with gear selection
lever.
2. Press parking brake lever down to handlebar.
3. Gently engage clutch lever.
To Move In Reverse
1. Stop forward travel of unit.
2. Move gear selection lever to reverse (R) position.
3. Press parking brake lever down to handlebar.
4. Check behind for obstacles and ensure that travel
path is clear.
5. Gently engage clutch lever.
To Stop Unit
1. Release clutch lever.
2. Release parking brake lever.
3. Reduce engine speed with the throttle control lever.
WARNING: AVOID INJURY. Read and
understand the entire Safety section before
proceeding.
Figure 8
Skip Release
Lever
Squeeze
lever to
release
skip lock
Figure 9
Fuel shut-off valve (Shown
in Closed position)