READ ALL DIRECTIONS CAREFULLY BEFORE BEGINNING
MOUNTING LOCATION:
The enclosure mounts behind the seat directly
behind driver in the Ranger or a Mazda B-Series regular cab trucks.
TOOLS REQUIRED FOR INSTALLATION:
Phillips Head Screwdriver Ratchet
5/16” Socket Wire Crimper
Wire Cutters 3/8” Drill Bit
Power Drill 7/32” Socket
INSTALLATION:
Follow the steps below
1.
Remove rubber mat from bottom of tray behind driver seat by pulling
up on tab. All models do not have this mat.
2.
Remove tray by removing four 7/32 bolts from tray. Retain these items
to replace if you sell the vehicle.
7/32" Bolts to be Removed
3.
Attach one bracket provided to bottom of enclosure front beneath
woofer. The other bracket provided attaches to the left side of the enclo-
sure at the top towards the rear of the enclosure as shown below.
21.
Screw enclosure into place as shown below.
Mounting Brackets
Factory Speaker Grill
For technical assistance call 1-800-CALL MTX.
These instructions are guidelines only and in no way are intended to
replace a professional installation. As always before screwing or drilling
check to make sure you will not damage any wires or hoses or cause
damage to the vehicle.
Warning:
Batteries normally produce explosive gases which can cause
personal injury. Therefore, do not allow flames, sparks or lighted sub-
stances to come near the battery. When charging or working near a
battery, always shield your face and protect your eyes. Always provide
ventilation.
Conventional Wiring of Aftermarket Radio
HIGH LEVEL
INPUTS
GAIN
CROSSOVER
+
-
LINE LEVEL
INPUTS
+
-
POWER
GND
REMOTE
STATUS
15 Amp Fuse
Low Level Signal
Turn On Lead
1
6
