R e l i a b l y S e r v i n g a T h i r s t y W o r l d
®
1770 Brackett St., La Verne CA 91750 USA
•
T:
909-629-7301
•
F:
909-629-7380
•
www.mtnproducts.com
•
POU Install
Troubleshooting
1.
Water not dispensing:
ALWAYS VERIFY THAT UNIT IS NOT IN MANUAL OR AUTO CLEAN MODE
a.
Check to ensure float assembly is not tripped.
b.
Verify cooler is connected to a working outlet.
c.
Verify water shut off valve is in open position.
d.
Ensure filters are not blocked.
e.
Check to make sure solenoid and water pump are operating.
2.
Warm water dispensing from cold side:
a.
Verify usage is not exceeding GPH cooling capacity (approx.
1
GPH)
b.
Cooler set in direct sunlight or too close to heat source.
c.
Check cold thermostat setting.
¼
turn clockwise for colder water.
3.
Water dispensing from hot mode is not hot:
a.
Verify switch on rear of cooler is in “On” position. Switch will light up when hot control is activated.
4.
Hot water is boiling:
a.
Possible air pocket in hot tank. Dispense hot water to bleed off air pocket.
DSW-Filtration Install Guide:pub-8.29.11:rev-9.19.11