MARKINGS ON THE MTM17-33 HEATER
[CAUTION! HIGH TEMPERATURE!]
[DO NOT TOUCH THE FUEL OUTLET
AND THE STACK! RISK OF BURN!]
THERMOSTAT
STB
FUEL
INLET
9. The heater operation
CAUTION!!!
OIL MUST NOT BE POURED INTO THE FUEL TANK DURING DEVICE OPERATION. OIL MUST
NOT BE POURED INTO THE FURNACE AND IT MUST NOT BE FIRED UP IF THE FURNACE
CHAMBER OR BOWL ARE STILL HOT!!! ALWAYS WAIT UNTIL THE BURNER PLATE
HAS COOLED DOWN ENTIRELY.
FAILING TO FOLLOW THE ABOVE INSTRUCTIONS MAY RESULT IN AN UNCONTROLLED
IGNITION OF OIL FUMES AND SCALDING. IT MAY ALSO CAUSE DESTRUCTION OF
CAST IRON ELEMENTS!!!
Switching the device on
While starting the device, the user may stand on the left or right side or in front of the device. Caution
is advised so that the flap of the device does not slam the hands. Therefore, the user must not perform
any actions intended to start the device when they are behind it.
After start-up, the heater enters proper phases of operation depending on the settings provided by the
user and information fed by the sensors in the control system.
•
Remove water from the fuel tank and fill it with oil (e.g. used oil) if necessary.
•
Check whether the feeding pipe (burner) of the device is maximally pushed to the device housing (if
not, push it).
•
Insert the power plug in the power socket (230V / 50Hz) - the diode
STANDBY
lights up.
•
Draw the top part of the heater housing aside and remove the combustion chamber cover.
Then, take the deflector out (if necessary, thoroughly clean the combustion bowl, the base which
it is placed on and the entire combustion chamber).
•
Check whether the furnace bowl is cool and clean and pour ca. 250 ml of fuel or diesel oil.
•
Install the deflector.
•
Fire the oil up using paper crumbled into a ball - set it on fire and throw onto the furnace bowl.
•
Replace the combustion chamber cover, fastening it with locks, and close the top housing part
of the heater.
•
Press the
Start
button on the control panel (the diode
OPERATION
will start to blink).
•
After about 10-15 minutes, depending on the room temperature, the fuel pump and the fan
will activate and the stove will start to operate on the minimal power, regardless of the
position of the power regulating knob (30 kW; combustion at ca. 3 l/h). After 30 minutes, it will be
possible to regulate the device power with the regulating knob. If the knob, at start-up,
was
in
another
position
than
minimum
,
the
device
will
automatically
start
operating with the power set by the regulating knob position after 30 minutes.
