6
QSG 800LR-1.8
May 2010
6
Linking your transmitter and receiver units
You must reset the transmitter unit to factory defaults (to disable encryption)
before linking the transmitter and receiver units. For more information, see
the WIO-800LT Transmitter Quick Start Guide.
NOTE: You must complete the linking process in 60 seconds.
To link the transmitter and receiver units:
1. Press and hold down the RSSI Pushbutton on the receiver.
2. Power on the receiver while holding down the RSSI Pushbutton
3. Release the RSSI Pushbutton as soon as the Receiver LEDS flash (within
5 seconds of powering the receiver).
4. The receiver will flash all LEDs for a maximum 60 seconds while it tries to
link to the transmitter.
5. Power on the transmitter. The transmitter sends a special “Link” message
to allow the receiver to recognise the transmitter.
6. When the units link, the receiver lights all LEDs for 2 seconds before
returning to normal operation.
NOTE:
If the receiver LEDs continue flashing within the 60 seconds, the
units are not linked and you should retry the linking process by powering the
transmitter off and on again. If you exceed the 60 seconds, you must restart
the linking process from step 1.
You can now bench test your configuration before deploying.
7
Safety information
Thank you for selecting the WIO-800LR receiver for your telemetry needs.
We trust it will give you many years of valuable service. To ensure your
WIO-800LR receiver enjoys a long life, double-check ALL your connections
with the user’s manual before powering on the unit.
WARNING: Incorrect termination of supply wires may cause internal damage
and will void warranty.
