2
QSG 800LR-1.8
May 2010
ABOUT THIS DOCUMENT
This is the Quick Start Guide for the
MTL WIO-800LR
Wireless I/O Receiver
Unit and contains the following sections:
Section
Read this section if you want to …
1
Basic steps for
using your unit
Learn the basic steps for installing and using
your unit.
2
Factory default
configuration
Understand how the transmitter sends
information to the receiver.
3
Unit components
Understand the different parts of your unit.
4
Antenna installation
Learn how to install an antenna with your unit.
5
Resetting factory
defaults
Reset your unit to the original factory default
settings.
6
Linking Tx and Rx units
Link your units to work as a dedicated pair.
7
Safety information
Understand important safety information related
to your unit.
NOTE
: You must read this information before
installing your unit.
8
Specifications
See the technical information.
For more information, see the following sections.
1
Basic steps for using your unit
This document describes how to configure your unit using the default factory
configuration that lets you easily setup your network as a simple send/receive
network using a dedicated pair of transmitter and receiver units.
The basic steps for using your unit are:
1. Connect the antenna power supply and transducer signals using the
instructions in this document. Power supply and transducer connection
is described in the section Unit components and connections. Antenna
connection is described in the section Antenna installation. For more
information, see the WIO-800L Installation Manual.
2. Reset the transmitter and receiver units to the factory default configurations.
3. Link the transmitter and receiver units to work as a dedicated pair.
4. Bench test your configuration before deploying.
NOTE: You can also configure your network using a user-defined customised
configuration that lets you set specific information about your network. For
more information on setting a user-defined customised configuration, see the
WIO-800L User Manual on the enclosed CD.
2
Factory default configuration
When you configure the units using the configuration in this document, the
inputs from the transmitter are sent to the outputs at the receiver as follows
WIO-800LT(Transmitter)
Sends
WIO-800LR (Receiver)
Digital Input 1
_
Digital Output 1
Digital Input 2
_
Digital Output 2
Analogue Setpoint
_
Digital Output 3
Analogue input (4-20 mA)
_
Analog output (4-20 mA)
Thermocouple Input (Not used)
Communication Failure
(Comes on if no messages
from WIO-800LT)
Setpoint Output (Local indication)
System OK (On if system OK)
System OK (On if system OK)
