FREEDOM CORE II
™ POWER/SCREAMER SENSOR
4
MTI P/N 063-00229 rev A ©2018 MTI All Rights Reserved
www.mobiletechinc.com | T:800.426.6844
1
3
5
2
4
6
Double Sided
System Tool
A.
B.
Use the pin for
alignment.
The socket-outlet shall be installed near the
equipment and shall be easily accessible.
Clean the demo device with an alcohol swab and let
air dry or wipe dry with a clean cloth.
Peel the red film
from the VHB adhesive on the Sensor.
If not using
GeniusCables, skip to step 6.
Using the Double-Sided System Tool, turn clockwise
and then twist to remove the Sensor from the base
plate.
Insert the desired GeniusCable into the Sensor port.
The Sensor
must be detached
from device before
GeniusCable can be installed. GeniusCable is locked
into the Sensor after re-installation.
Connect GeniusCable to device.
Using the pin on the Sensor for alignment, twist the
Sensor onto base plate until it snaps and locks into
place.
Use the individual power supply and plug it into the
nearest outlet.
MERCHANDISING
-CONTROLLED DOCUMENT-
063-00229
A-0
Status: Approved
ECO-106737
ECO-106737
