C L E A N I N G I N S T R U C T I O N S
CLEANING INSTRUCTIONS FOR THE ACRYLIC SHELL
The cross-linked cast acrylic surface of all MTI BASICS whirlpools, air baths and soaking baths is
among the glossiest, highest quality surfaces available. Its hard, non-porous surface prevents dirt from
accumulating and resists stains better than other materials. With normal use, cast acrylic will retain its
beauty with only a minimal amount of care. To maintain the high gloss, elegant look of the cast acrylic
surface, follow these simple steps:
1. Use common household,
non-abrasive
cleaners for most cleaning jobs (for example: a mild
dishwashing detergent such as Ivory Liquid). Follow manufacturer’s directions and precau-
tions. Rinse well and dry with a soft, clean cloth. Be sure to check the product label. Some
products, although not containing abrasives, WILL damage the acrylic over time.
Never use any type of “scrubbing bubbles” on your acrylic product unless it
specifically states that it is safe for use on acrylic!
2. Never use abrasive cleansers. If any product feels gritty when rubbed between your
fingers, do not use on the acrylic surface or controls as permanent damage will occur.
3. Do not allow your cast acrylic surface to come into contact with nail polish, nail polish
remover, Wintergreen oil, dry cleaning solution, lacquer thinners, gasoline, pine oil, etc.
4. Remove dust and dry dirt with a soft, damp cloth.
5. Clean grease, oil, paint or ink stains with isopropyl (rubbing) alcohol. Dry with a clean, soft cloth.
6. Avoid using razor blades or other sharp objects that might scratch the surface. Small scratch-
es can be removed by applying a thin coat of automotive paste wax and buffing lightly with a
clean cloth. For deeper scratches, sand the surface lightly with a 400 grit “wet or dry” paper
and buff with a fine grit buffing compound.
MTI strongly recommends a professional acrylic repair person for deep scratches or chips.
CLEANING INSTRUCTIONS FOR WHIRLPOOL SYSTEMS
THE WHIRLPOOL SYSTEM SHOULD BE CLEANED PERIODICALLY. MTI WHIRLPOOLS
RECOMMENDS CLEANING AT LEAST ONCE A MONTH, NOT TO EXCEED 90
DAYS BETWEEN CLEANINGS. ALWAYS USE CAUTION WHEN USING CHLORINE-
BASED PRODUCTS IN CONJUNCTION WITH OTHER CLEANING PRODUCTS. THE
POSSIBILITY OF HARMFUL FUMES COULD RESULT. ALWAYS RINSE THOROUGHLY.
Fill tub with warm water 2” above the highest jet and add
one
of the following to the bath water: 1/4 cup
of MTI Baths’ Fresh Wave Cleaning Solution, 1 cup vinegar,
or
several drops of a low sudsing detergent
mixed with 1 cup warm water. Turn the system on for five minutes then let stand for an additional 15 min-
utes. Drain the tub and refill with cold water. Restart the system for 1
-2
minutes then drain.
Rinse interior
of tub with clean water.
11
