1
1
3
2
2
3
SECURE PLUG
™
PRODUCT MANUAL
6
MTI P/N 063-00243 rev D ©2019 MTI All Rights Reserved
www.mobiletechinc.com | T:800.426.6844
DELETING USER KEYS
ARMING/DISARMING THE SYSTEM
SILENCING THE ALARM
Place any User Key over the RFID
icon and the LED will change from
flashing white to solid white to
silence the alarm.
After the problem has been fixed,
place any User Key over the RFID
icon and the LED will change
from flashing white to solid white,
arming the system.
Fix the problem that caused the
alarm.
Two causes of alarms
•
The device was unplugged at either
end of the power cord.
•
The device is still connected but has
completely shut down. Some devices
will generate alarms in this state and
some will not. If an alarm occurs
change the settings on the device
to prevent it from powering down or
run a demo loop or other content to
prevent it from powering down.
Arming
Resolving Miscalibration
Place any User Key over the RFID icon and the LED
will change from flashing white to solid white to indicate
Armed.
Secure Plug will beep for 5 seconds while verifying all
sockets have been calibrated and connected correctly.
If no errors have occurred, the LED will change from
flashing white to white and the system is armed.
If an error occurred, the LED will blink red and the
system will emit a repeating series of four double beeps
and the RAM will indicate which
socket has an error.
For error resolution see the LED
Status Indications section of this
document.
Note: Any properly calibrated
position will still arm.
From an Armed state, place the
User Key over the RFID icon to
disarm the system. LED will be
flashing white.
Hold down the Authorization Card
for 5 seconds, LED will be solid
yellow.
Place the Authorization Card over
the RFID icon AGAIN while LED is
yellow.
If successful
unit beeps 2 times
and the LED will turn solid green
If unsuccessful
unit beeps 4
times (retry)
-CONTROLLED DOCUMENT-
063-00243
D-0
Status: Approved
ECO-109326
ECO-109326
