QUICK START GUIDE
Of course, you should read your manual over before running your
powered car. But if you just can’t wait, choose which control method that
you use from the list below. Follow the steps outlined in your section, run
your powered car and enjoy! Now, after a few minutes, shut down the
powered car and read through your engineer’s guide.
I USE A REGULAR DC SUPPLY…
Step 1: Unpack your subway set.
Step 2: Set the powered car on the track
Step 3: Apply 6-8VDC voltage until she starts up and then increase to
pull out.
I'M A DCC OPERATOR…
Step 1: Unpack your subway set.
Step 2: Set the powered car on the track …
Step 3: Power up your DCC system…
Step 4: Select engine address 3 and press “F3” to start her up…
Step 5: Turn the throttle and head on down the pike…
I RUN DCS…
Step 1: Unpack your subway set.
Step 2: Set the powered car on the track …
Step 3: Power up your DCS system…
Step 4: Add the powered car to your system and start her up…
Step 5: Turn the throttle and move out…
CAUTION:
M.T.H. HO powered cars
DO NOT OPERATE ON AC
VOLTAGE
. Applying AC power to your locomotive could cause
permanent damage and will void your warranty.
Please note, when making setting changes in DCS or DCC, such as
address, please wait a minimum of 5 seconds after removing power to
ensure the settings are stored in the engines memory. Reapplying power
in less than 5 seconds may result in losing the setting changes.
M.T.H. HO Subway Car w/Proto-Sound 3.0
3