b. To save as an Out-and-Back:
i. Ensure the engine is sitting at the final station you
programmed in step 4.
ii. Press F2 On/Off again and the engine will announce, “Save
Complete” and the engine will go back to the normal engine
sounds.
iii. Advance the throttle and drive the engine to the first station
you saved.
You are now ready to run the engine in Auto Mode (F7).
To run in Auto Mode:
1. Drive or set the engine at the first station you programmed earlier. It’s
important that you be as exact as possible where you start the engine to
minimize any drift the engine might have from the physical station stop.
2. Press F7 so it’s On. The engine will announce, “Auto Mode”.
3. Advance the throttle and the engine will automatically stop at the pre=-
programmed stops.
To make it stop at All or Random stations see the section on All/Random
Stops.
F11 – Custom Sound 2
Custom Sound 2 is a pre-programmed sound that you can call up at will
by pressing F11 On then Off. It could anything from an ambient station
sound to a conductor’s voice. It will be the same sound each time you
trigger it.
F12 – All/Random Stops
You can control whether the engine stops at all the pre-programmed
stops taught to it in Learn Mode or at Random stops along the route. To
do this:
1. While the engine is running or while it’s stopped, doesn’t matter; press
the F12 button so it’s On. Once F12 is active you are now telling the
engine to stop at Random stops along the route. To make it stop at ALL
stops along the route turn off F12
F13-F16 – Idle Sequence
Pressing F13, F14, F15, or F16 twice (toggling on then off) will trigger an
Idle Sequence if the engine is not moving. These vary from engine to
engine and may include things like checking the coal load, checking the
water level, using the Alemite grease gun on the drivers, etc. When
triggered, these will run through the sequence that varies in duration.
NOTE:
The engine must be sitting still in order to trigger these
M.T.H. HO Subway Car w/Proto-Sound 3.0
17
