MTD White Outdoor 12A-465E790, Руководство оператора

Страница: 7 / 20

7
SECTION 3: ASSEMBLING YOUR LAWN MOWER
Removing Unit From Carton
• Remove staples, break glue on top flaps, or cut
tape at carton end and peel along top flap to open.
• Remove loose parts included with unit (i.e.,
operator’s manual, oil, etc.).
• Cut corners and lay carton down flat. Remove
packing material.
• Roll or slide unit out of carton. Check carton
thoroughly for loose parts.
NOTE: Make sure not to crimp cables while removing
loose parts or the entire unit from the carton.
Tools Required
• Pair of Pliers
• Funnel
NOTE: Reference to right or left hand side of the mower
and/or front or behind the mower is observed from the
operating position.
Hardware Pack
Please identify each piece of the
hardware pack as shown in
figure here.
Disconnecting Spark Plug
• Before setting up your lawn mower, disconnect the
spark plug wire from the spark plug, and ground it
against the engine.
Assembling Handle
• Remove grass bag from the unit and set it out of the
way.
• Remove any packing material which may be
between the upper and lower handles for shipping
purposes.
Figure 1
• Raise the lower handle, as shown in Figure 1 , until
it snaps into place.
• Raise the upper handle as shown in Figure 1 .
Tighten the wing nuts which are already on the
handle. See Figure 2 .
Figure 2
NOTE: Make sure to route the cables inside the lower
handle. Also do not crimp the cables while lifting the
handle up.
• For shipping purposes, the hairpin clip is placed in
the outer hole of the weld pin on the lower handle.
Remove the hairpin clip from the outer hole of the
weld pin. See Figure 3.
• Using a pair of pliers, insert the hairpin clip into the
inner hole on the weld pin. Repeat on other side.
See Figure 3 .
Figure 3
• Insert the carriage bolt, included in the hardware
pack, in the upper hole on the handle mounting
bracket (carriage bolt must go to the inside of
handle). Secure with one plastic wing nut, also
included in the hardware pack. Repeat on the other
side with remaining items from the hardware pack.
• Attach cables to the lower handle with the cable ties
already on the lower handle. Insert pegs on cable
ties into the holes on the lower handle. Pull cable
ties tight and cut off the extra.
Wing
Carriage
Bolt (2)
Nut (2)
Tighten these
wing nuts
Lower
Handle
Upper
Handle
Carriage Bolt
Wing Nut
Upper
Move Hairpin Clip
Handle
Mounting
Brkt.
Hole