background image

English  

Operating 

instructions 

 

10

Warranty 

The warranty rules issued by our 
company or the importer apply to 
every country. 
As part of the warranty, we remedy 
malfunctions on your vehicle free of 
charge provided that this malfunction 
is caused by a material or 
manufacturing defect. In the event of 
a warranty claim, please turn to your 
dealer or the nearest branch office. 
 
 
 
 
 

Information on the 
engine 

The manufacturer of the engine is 
liable for all engine-related problems 
with respect to output power, power 
measurement, specifications, 
warranties, and service. More detailed 
information can be found in the 
owner / operator handbook provided 
separately by the engine manufacturer. 
 

Assistance with 
malfunctions 

 

 

Danger! 

Accidentally starting the engine can 
cause injury. 

Protect yourself from injury, above all 
when working on the vehicle. 

• 

Switch off the engine. 

• 

Engage the parking / locking 
brake. 

• 

Take out the ignition key. 

• 

Wait until all moving parts have 
come to a complete stop and the 
engine has cooled down. 

• 

Disconnect the spark plug terminals 
on the engine so that it cannot start 
by accident. 

Malfunctions when your appliance is 
operating often have simple causes 
that you should know and be able to 
(partially) eliminate yourself. In cases 
of doubt your specialised garage will 
be pleased to assist you further. 
 
 

 
 

 
 
 

Problem Possible 

cause(s) 

Remedy 

Engine does not start  Safety lock system activated 

 
 
 
 
Battery not connected correctly 
 
 
Depleted or low battery 
 
Fuse has tripped 

To start the engine sit on the driver’s seat, move 
both drive control levers into the outer Neutral 
recesses, engage the locking brake, and switch OFF 
the PTO switch. 
 
Connect the black cable to the (–) terminal and the 
red cable to the (+) terminal on the battery. 
 
Charge the battery. 
 
Replace the fuse. If the fuse trips repeatedly look for 
the cause (in most cases a short circuit). 

Starter turns, engine 
does not start 

Choke and accelerator lever at wrong 
positions 
 
No fuel supplied to the carburettor 
 
Defect or soiled spark plug 
 
No spark 

See the section “Starting the engine”. 
 
 
Petrol tank empty. Refill. 
 
Check the spark plug (see engine handbook). 
 
Ignition must be checked at a specialised garage. 

Smoke from engine  Too much engine oil in the engine or engine 

defect 

Immediately switch OFF the appliance.  
Check the engine oil level. 
The engine must be checked at a specialised garage. 

Strong vibrations 
 

Damaged cutter shaft or defect cutters 

Immediately switch OFF the appliance. Defect parts 
must be replaced at a specialised garage. 

Cutters do not eject 
grass, or cut ragged 

Low engine speed or too high drive speed 

Raise the engine speed or lower the drive speed. 

 

Troubleshooting 

Содержание L04
















Отзывы: