MTD 19A30003000, Руководство оператора

Страница: 12 / 52

12 s
ectiOn
4 — a
sseMbly
& i
nstallatiOn
Install both grass bags onto the bag support assembly 8.
by inserting the front edge in first (1), as seen in Fig. 4-19,
and setting the back edge down (2) until it fits into the
assembly.
Install one of the rubber chute straps onto the chute elbow 9.
using one of the supplied clevis pins (711-05063), washer (736-
0204) and Bow-tie cotter pins (714-04040) from hardware
pack 689-00092B. See Fig. 4-20. Secure the end of the strap
utilizing the hole furthest from the end, insert the torsion
spring hook (732-04510A) into the other end.
Install the deck mounting pin (711-05049), along with two flat 10.
washers (736-0176), up into the chute elbow using hardware
pack 689-00092B and secure with a flange lock nut (712-3027),
as seen in Fig. 4-20.
Install the shoulder bolt (738-0754) into the chute elbow from
11.
the top side and secure inside the chute elbow using a flange
lock nut (712-04063) from the same hardware pack (689-
00092B). See Fig. 4-20.
Slide the hinge pin into the hole located on the mounting 6.
tab, as in Fig. 4-16. Use the cut-out window (See inset in
Fig. 4-16) to line up the hinge pin on the other side and
push pin all the way in until it reaches the end-stop. At this
point the pin clips into place and is secured by a tab in the
bagger cover. See Fig. 4-17.
Open Hood by pushing in on the rear, right-side tab with 7.
your right hand, as seen in 1 of Fig. 4-18, and lifting the cover
with your left hand in the center rear of the bagger cover, 2.
1
2
1
2
Figure 4-18
Figure 4-19
Figure 4-17
Figure 4-16