
Figure 3-3
Figure 3-4
Outside of Bracket
Outer Hole
Support
Bracket
Screws
Removed
Earlier
Assembling Support
Brackets
Model Series 0 through 99
IMPORTANT: Before assembly, place the tractor on a
firm, level surface, disengage the PTO, stop the tractor
engine and set the parking brake.
1. Remove the top four self-tapping screws from the rear
of the lawn tractor. See Fig. 3-3 on the previous page.
2. Place the right hand grass catcher support bracket (F1
from Fig. 2-2), in position, with the wide end on top and
the narrow end pointing down as shown in Fig. 3-4.
3. Secure the support bracket to the tractor frame with two
self-tapping screws earlier removed. Refer to Fig. 3-4.
Repeat on the other side using part F2 from Fig. 2-2.
NOTE:
If the grass collection system is removed for
any reason, it is not necessary to remove the support
brackets from the tractor.
4. Insert a shoulder bolt (C in Fig. 2-2) through a bell
washer, (B in Fig. 2-2) and insert the bolt from the
outside of the bracket through the outer hole on the
support bracket. Secure with a nut (A in Fig. 2-2). See
Fig. 3-4 for details. Repeat on other side.
NOTE:
The reference above to “the outer hole” means
the hole furthest away from the frame.
Attaching
Support
Bracket
Model Series
650 through 699
IMPORTANT:
Before assembly, place
the tractor on a firm,
level surface, disengage
the PTO, turn off tractor
engine and set the
parking brake.
NOTE:
If the grass collection
system is removed for
any reason, it is not
necessary to remove the
support brackets from
the tractor.
NOTE:
The reference above to
“the outer hole” means
the hole furthest away
from the frame
.