CAUTION: THE SEPARATOR IS PROVIDED WITH PLASTIC NPT PIPE
FITTINGS. THE PLASTIC THREADS CAN BE DAMAGED IF
OVERTIGHTENED WITH METAL FITTINGS. IT IS SUGGESTED THAT
PLASTIC FITTINGS BE USED OR OTHER MEASURES TAKEN TO PREVENT
SUCH DAMAGE!
SAFETY AND ENVIRONMENTAL CONSIDERATIONS
All normal safety precautions should be taken with this equipment to
prevent accidents and fires.
Normal fire prevention measures must be taken to prevent fire danger
from the separated oil.
Care should be taken to keep the area around the separator clean to
prevent accidents.
Dispose of the separated oil properly, preferably by recycling.
When full of water, separator is heavy.
Separator is not designed to be moved full of water. Drain before moving.
SAFETY AND ENVIRONMENTAL PROTECTION ARE THE
RESPONSIBILITY OF THE USER. MOHR SEPARATIONS RESEARCH
ASSUMES NO LIABILITY FOR MISUSE OF THIS SEPARATOR OR
FOR USE OUTSIDE THE PARAMETERS FOR WHICH IT IS DESIGNED.
INITIAL INSTALLATION REQUIREMENTS
The separator must be installed as level as possible, preferably within 1/8" per
foot. Excessive slope of the unit may adversely affect performance.
To install the separator, follow these steps: (
Please refer to attached cross-
sectional flow schematic above
)
Place the separator in the position near the water source to be purified.
Install inlet pipe, allowing at least 10 pipe diameters of straight pipe into
the separator.
Install outlet pipe and downstream equipment. Be careful to avoid damage
to the threads in the connections.
Install valves or plugs in the drain and oil outlet connections.
INITIAL CHECK
Before putting the MSR-11P unit in service initially or after maintenance, the
following startup-check procedures should be performed.
Ensure that the unit is installed in a level position and check inlet and
outlet connection to ensure that they are properly made and leak tight. Be
careful to avoid damage to the threads in the connections.
