MSR Intec Controls PolyGard CO LC-1112 V3 Скачать руководство пользователя страница 13

Страница: 13 / 13

Customer Services (858) 578-7887 & (888) GO IN

TEC

Controls, 12700 Stowe Dr., Suite 1

0, Poway, CA 92064

Fax (858) 578-4633 & (888) FX IN

TEC

www.inteccontrols.com

Specification subject to change without notice.

Printed in USA 140916

Polygard® is a registered trademark of MSR

UMLC1112I01

PolyGard

CO Transmitter

User Manual - LC-1112 V3

Page 13

11 Notes and General Information

It is important to read this user manual thoroughly and clearly understand the information and instructions. The

PolyGard

transmitters must be used within product specification capabilities. The appropriate operating and

maintenance instructions and recommendations must be followed.
Due to ongoing product development, MSR reserves the right to change specifications without notice. The

information contained herein is based upon data considered to be accurate. However, no guarantee is expressed

or implied regarding the accuracy of this data.

11.1 Intended product application

The PolyGard

CO LC-1112 transmitters are designed and manufactured for control applications for energy

savings and OSHA air quality compliance in commercial buildings and manufacturing plants (i.e.,detection and

automatic exhaust fan control for automotive maintenance facilities, enclosed parking garages, engine repair

shops, warehouses with forklifts, fire stations, tunnels, etc.).

11.2 Installers` responsibilities

It is the installer`s responsibility to ensure that all PolyGard

transmitters are installed in compliance with all

national and local codes and OSHA requirements. Installation should be implemented only by individuals

familiar with proper installation techniques and with codes, standards and proper safety procedures for control

installations and the latest edition of the National Electrical Code (ANSI/NFPA70). It is also essential to strictly

follow all instructions as provided in the user manual.

11.3 Maintenance

It is recommended that the PolyGard

transmitter performance check is done on a routine schedule. Any

performance deviations may be serviced based on needed requirements. Re-calibration and part replacement

may be implemented in the field by a qualified individual and with the appropriate tools. Alternatively, the easily

removable plug-in transmitter card with the sensor may be returned for service to IN

TEC

Controls.

11.4 Limited warranty

MSR-Electronic-GmbH and IN

TEC

Controls warrants the PolyGard

transmitter for a period of two years,

12 months normal exposure for the sensor, from the date of shipment against defects in material or workmanship.

Should any evidence of defects in material or workmanship occur during the warranty period, IN

TEC

Controls will

repair or replace the product at their own discretion, without charge.
This warranty does not apply to units that have been altered, had attempted repair, or been subject to abuse,

accidental or otherwise. The warranty also does not apply to units in which the sensor element has been

overexposed or gas poisoned. The above warranty is in lieu of all other express warranties, obligations or liabilities.
This warranty applies only to the PolyGard

transmitter. MSR-Electronic-GmbH and/or IN

TEC

Controls shall

not be liable for any incidental or consequential damages arising out of or related to the use of the PolyGard

transmitter.
If the PolyGard

transmitter needs to be returned to IN

TEC

Controls for service, an RMA number must be obtained

prior to sending.

Specifications subject to change without notice. | USA 140916 | Page 13 of 13

12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.IN

TEC