Jet Operation
CONTROLLER OPERATION
Heater Button
LED Display
Bubble Button
- Adjust the bubble level by pressing
the button (L1: 300W, L2: 500W, L3: 720W
Up Button
Filter Button
Timer Button
Down Button
JET Button
UVC Button
OZONE Button
11
●
●
●
●
LED display
Once powered-up, press the
RESET
on the PRCD. The LED displays the current water temperature automatically.
NOTE:
The actual water temperature may vary from the temperature displayed on the LED screen by as much as approximately 1°C.
JET Button
Press the
JET
button to turn the water jet massage function on and off. The light above the JET button displays green when activated.
NOTE:
The
BUBBLE
button can only be adjusted to L1 or L2 when the JET system is activated.
NOTE:
The
JET
system will shut off automatically after one hour.
HEATING
1. Press the
HEATER
button to turn the heating system on/off. When the light above the heat button is red, the heating system is activated.
When the light is green, the water is at the set temperature and the heating system is at rest.
2. Pressing the
UP
or
DOWN
button will cause the LED to flash. When it is flashing you can adjust the water to the desired tempera
ture setting (from 20°C to 40°C ). The new and desired temperature setting will remain on the LED display for 3 seconds to confirm the new value.
NOTE:
The default temperature is 38°C.
NOTE:
If the heating system is turned on, the filtration system will automatically start.
NOTE:
When the water temperature is below 1°C (33.8°F), the anti-icing system will be activated automatically to heat the water to 3°C (37.4°F).
IMPORTANT:
The following conditions will lead to slow water heating
An ambient temperature lower than 10°C (50°F).
An outdoor wind speed above 3.5-5.4m/s (8-12mph).
If the air bubble function is activated when the heater is on.
If the spa cover is not properly in place when the heater is on.
Adjust the jet nozzles (a) to change the water stream directions.
Turn the jet control knob (b) to change the water stream setting.
°C
°F
HEATER
HEATER
UP
DOWN
20-40
°C
close open
(
a
)
(
b
)
