22
TROUBLESHOOTING
PROBLEM
CAUSE
SOLUTION
NO DISPLAY ON
THE CONTROL
PANEL
Power failure
PRCD is off
PRCD broken
Check power supply
Contact the MSpa Service Center
NOT HEATING
PROPERLY
Temperature set too low
Heating element failed
Low water level
Set a higher temperature
Contact the MSpa Service Center
SPA LEAKING
Spa in&outlet connection not
securely tight
Tighten the in&outlet connection
Reset PRCD by following PRCD Testing
section
LED
READING
CAUSE
SOLUTION
E0
Contact the MSpa Service Center.
Adjust water temperature
ERROR CODE CHART
Water temperature is lower than zero degree
or exceed 55°C
Temperature sensor failure
Water leaks from the spa
pool body
Drainage valve is not closed
completely
Close the drainage valve. Contact the MSpa
Service Center, if spa is still leaking
5HSDLUWKHOHDNLQJKROHVSLOWZLWKWKHUHSDLU
kit material
Add more water to reach the minimum
water line
E1
E1 immediately shows after pressing
FILTER or HEATING
Clean parts and tubes that water goes through
1. Add more water to the minimum line;
2. Clean parts and tubes that water goes through;
3. Contact the MSpa Service Center.
E1 shows 15s after pressing FILTER
or HEATING