13
SPA SET-UP
Move the entire package to a selected site. Open the carton carefully as it can be re-used to store the spa
during long term storage or when not in use.
Lay out all the parts on the ground and make sure all parts are accounted for. Make sure the spa tub is
right side up. (*For missing or damaged part, contact the MSpa Service Center)
1.
2.
1
2
Square models: Spread
out the square ground mat
and place it to the selected
site. Make sure the buckle
of cover and mat is
attached when spa not in
use.
Ɣ
this side
face down
Spa Inflation
3.1 Open the air blower inflation outlet and connect with the inflation hose as Figure 3.1.
3.2 Unscrew the air valve cap on the spa pool and reveal the stem for inflation.
3.3 Connect the other end of the inflation hose (b) to the manometer (c) first and then insert to the air
valve.
3.
3.3
(b)
(c)
3.1
11
3.2
(a)
3.4 Press the Bubble button to start inflation until you can see the YELLOW section on
manomater.
CAUTION: Do not over inflate. Over inflation may cause spa leakage and void the warranty.
3.5 Pay attention to the Manometer. The Yellow section appears when the spa is properly inflated. The
Green section shows when water filling is completed. Repeat previous steps if more air is necessary.
CAUTION: The Red section shows when the spa is over inflated. Press the black button (a) on the
manometer to release some air until it points the green section.
IMPORTANT: During spa use, the manometer shall only show the Green section at all times.
BUBBLE
