mspa Birkin M-123S, Руководство пользователя

Страница: 11 / 26

11
Verify the supporting floor can support the filled weight of spa with maximum number of occupants. Check
with a qualified contractor or structural engineer to verify the requirement.
Make sure the floor is water resistant and provides non-slip surface. Do not install the spa on a carpet of
any other material that could damaged by the moisture.
Humidity is a naturally side effect of indoor spa installation. The room shall be properly ventilated to allow
moisture to escape. Install a ventilating system to prevent excess condensation moisture in the room.
Additional requirements for indoor installation
Make sure to set up the spa on a firm, level and smooth surface that is strong enough to support the full
weight of the filled spa and maximum occupants.
Do not set up the spa on grass or dirt, as this increases the amount of debris entering the spa, and
damage the spa floor.
Do not leave the spa tub exposed to direct sun light for extend period of time.
It is the possible to install and leave the spa outside at a temperature not lower than 4°C and the water
inside the circulation system, pump, pipe are not frozen. Put a Heat Preservation Mat (*Optional) or the
Electric Heating Mat (*Optional) in between the spa bottom and the ground to prevent heat loss from the
bottom of the spa and to provide better heat retention.
Additional requirements for outdoor installation
RESET
TEST
Plug the machine into the mains.
Press the
RESET button on the RCD. The indicator turns red.
Press the TEST button on the RCD. The RCD indicator should shut off. If the RCD indicator does not turn off,
the RCD is faulty.
Do not use the spa. Contact a qualified electrician to correct the fault.
Press the
RESET button on the RCD again. The indicator should turn red. If yes, the spa is ready for use.
1.
2.
3.
4.
RCD or PRCD Testing
Risk of electric shock: This product is provided with a RCD located at the end of the power cord. The RCD
must tested before each use. Do not use the spa if the RCD does not function properly. Disconnect the
power cord until the fault has been identified and corrected. Contact a licensed electrician to correct the
fault. There are no serviceable parts in side the RCD. Opening the RCD will void the warranty.
PRCD
For spa models of Switzerland markets, test the PRCD using the above testing steps.
1. 2.
RESET
3.
TEST
4.
Indicator area
! WARNING