English
Operation manual
15
To replace the shock absorber fixation device in the lower pneumatic clamp, it is necessary to
unscrew the mounting screw pos.6 fig. 5 and pull out the device. Next, set the device to stop and
spin the installation screw.
Figure 12. Replacement of the shock absorber fixation in the lower pneumatic clamp.
4.2. Mounting the shock absorber on the test bench
The shock absorber shall be mounted on the bench in the following sequence:
1. Turn on the bench.
2. Pull the shaft out of the shock absorber to the maximum value.
3. Place and fix the shock absorber in the upper clamp with the shaft up, for this:
3.1 Position the top mounting of the shock absorber (prism) coaxially with the pneumatic clamp
pushers (see fig. 15) and «Clamp» it.
3.2. Alternately rotating pushers (see pos.5 of Figure.4) position the shock absorber so that its
shaft is located in the middle of the pneumatic clamp (Fig. 16). It is necessary to control the correct
positioning of the cams (see pos. 1. fig. 4), they must be fully extended (see fig. 17).
