110B, 110 PAGE, Q-6
| OWNER’S MANUAL
Please read the following instructions carefully before installing your Soundsphere
®
speaker. If you have any questions regarding
installation that are not answered in the following directions, please contact your local sound contractor or the Soundsphere
®
/
MSE Audio
®
technical support team. Contact information can be found on the back of the manual.
HK Hanging Kit
Hang Mounting from Above
The hanging kit is attached when ordered with the speaker from the factory.
If ordered separately, attach as shown in figure 1.
a) Hold the main hook above so the wires and 3 hooks will be straight as they are
clipped on the speaker.
b) Insert the spring clips into the bracket holes as shown. Attach the top clip to the
mounting point making sure that the clips and cable are not twisted.
MBS Mounting Bracket
Preparing the Speaker
The speaker is prepared for use with the MBS mounting bracket when both are ordered together from the factory. If ordered
separately, prepare the speaker as shown in figures 2 or 3, and 4.
a) Begin by removing the plastic flashing from the hole in the reflector rim so that
the screw can be inserted from the outside. Flashing can be removed with a 1/4”
drill bit (figure 2), or it can easily be punched through using a hammer (figure 3).
If using a 1/4” drill bit; be careful not to remove any material other than the flashing,
or the speaker will not install correctly.
b) Place the stop nut in the pocket as shown in figure 4. Start screw through outside
hole, through stop nut contained in the pocket, and slightly beyond the interior
hole (see figure 5).
