Table 1-6. SW3 Switch Settings
NOTE:
LEFT side of each SW3 Dip Switch indicates the ON position and
RIGHT side of each SW3 Dip Switch indicates the OFF position.
NUMBER
FUNCTION
1
SPARE (LEAVE IN OFF POSITION)
2
SPARE
3
OFF DELAY ON/OFF - CAUTION
4
OFF DELAY ON/OFF - WARNING
5
OFF DELAY ON/OFF - ALARM
6
*OFF DELAY TIME - BIT2
7
*OFF DELAY TIME - BIT1
8
*OFF DELAY TIME - BIT0
NOTE:
The delay time selected via switches 6 - 8
will apply to any delay switch(es) 3 - 5 in the ON position.
*OFF DELAY TIME
BIT2
BIT1
BIT0
TIME
(IN SECONDS)
OFF
OFF
OFF
5
OFF
OFF
ON
15
OFF
ON
OFF
30
OFF
ON
ON
60
ON
OFF
OFF
90
ON
OFF
ON
120
ON
ON
OFF
150
ON
ON
ON
180
Controller/Calibrator Operation
The Toxgard II Monitor is fully compatible with the Ultima
Controller and the Ultima Calibrator. These devices can be used
to set various parameters in the Toxgard II Monitor, including
alarm conditions, auto calibration configuration, etc.
The devices can also be used for calibrating the Toxgard II
Monitor. When using these devices, point them at the front panel
of the Toxgard II Monitor, aiming directly at the triangular IR
symbol (located next to the word "WARNING" at the center of
Chapter 1, Set-up
1-24
