MSA Rail Slider™ Anchorage Connector
17
Inspection
US
1
DIM “B”
2
Rounded portion of Rail Slider must be below edge of rail head.
3
MINIMUM MATERIAL THICKNESS: 3/16” (5 mm)
4
excessive wear
5
Minimum material thickness: 3/16” (5mm)
Remove device from service if material thickness is less than 3/16” (5 mm).
6
Ensure that bottom tip of Rail Slider will be below the side of the rail head.
The tip must not be adjacent to the side of the head of the rail when the slider is lifted as shown.
7
Check width opening of Rail Slider.
The distance between the tips (Dimension B) must be within the range provided in the table below.
