MSA OptimAir MM 2K, Инструкция пользователя

Страница: 15 / 32

TAL 0110 (L) Rev. 8 - 10020949
USING THE RESPIRATOR
3. Pull the harness over head with
loop, pull harness down to the back
of the head until plastic cradle lies
flat on back of head.
4. Tighten neck straps evenly so that
the mask is snug against your face.
DONNING THE FACEPIECE WITH
THE CLOTH HEAD HARNESS
1. Place neck strap, if present, around
your neck so that the facepiece lens
is against the body.
2. Loosen all the
harness straps.
Grip the bottom
straps.
3. Insert chin well
into the lower part
of facepiece, then
pull the harness
back over head.
4. Pull the back of
harness down-
ward until cen-
tered at the back
of the head.
5. Tighten the two
lower straps first
by pulling them
straight back, not
out. Tighten the
facepiece until the
mask is snug
against the face.
6. Tighten the two
side temple
straps in the
same manner as
described above.
Ensure that the
facepiece tabs
are not tucked under the face seal.
7. The top strap is not adjustable on
some models. Make sure the back
of the harness is centered on the
back of the head and the face seal
is providing uniform pressure on the
face at all points. Readjust straps if
needed.
FACEPIECE FIT CHECK
(Face-to-Facepiece Seal)
To test facepieces for leakage using a
negative pressure method:
1. Block the filter
opening.
15