MSA OptimAir MM 2K, Инструкция пользователя

Страница: 13 / 32

TAL 0110 (L) Rev. 8 - 10020949
USING THE RESPIRATOR
Do not wear this respirator unless
you have received training in its use
and have read all of the instructions.
Do not use this respirator in an area
that has less than 19.5% oxygen. The
PAPR does not supply oxygen. Do
not use the respirator as an under-
water device.
Do not use the respirator in an
atmosphere containing gas or vapor
contaminants. Do not use the respi-
rator if the air contaminant is
unknown or immediately dangerous
to life or health (IDLH).
The respirator filter is designed to
provide limited protection from spe-
cific contaminants. See the filter
label for specific information.
If you are working with a contami-
nant which can be absorbed by your
skin, wear protective clothing that
will not allow the contaminant to
contact your skin.
FAILURE TO FOLLOW THE ABOVE
WARNINGS CAN RESULT IN SERI-
OUS PERSONAL INJURY OR DEATH.
DONNING THE SUPPORT BELT AND
BATTERY PACK
1. Thread the belt through the belt
loops on the battery pack.
2. Don the support belt. The battery
pack may be worn on either side.
Adjust the battery pack to a com-
fortable position.
DONNING THE FACEPIECE
Cover lenses are installed on the out-
side of the facepiece lens to protect
the plastic surface. Do not use a
cover lens in a high heat environ-
ment. High heat can cause the cover
lens to distort.
ADJUSTABLE RUBBER HARNESS
1. Adjust the face-
piece headstraps
so the end tabs
are at the buckles.
2. Grip the headstraps between the
thumb and fingers with both hands.
Insert your chin into the chin cup.
3. Pull the facepiece headstraps over
your head. Smooth the straps flat
against your head.
4. To tighten the lower (neck) straps,
pull the straps straight back not out.
5. Tighten the side
(temple) straps.
6. Adjust the forehead strap if needed
to position the lens for best vision.
13