TAL 210 (L) Rev. 1 - 10022513
USING THE RESPIRATOR
DONNING THE ADVANTAGE 3000
MODEL 3100 SINGLE PORT OR
ADVANTAGE 4000 MODEL 4100 SIN-
GLE PORT WITH RUBBER
HARNESS
When using the Advantage 4000
Facepiece, ensure the inhalation
valve disc is laying flat against the
adapter orifice. Failure to follow this
warning can result in serious per-
sonal injury or death.
1. Loosen the two bottom harness
straps. Grip the straps by inserting
thumbs through the straps. Insert
chin well into lower part of face-
piece and pull harness back over
head.
2. Push the back of the harness
downward toward the neck until it
is centered at the back of the
head.
3. If necessary hold the mask com-
ponent housing with one hand and
position the harness with the other
hand, until obtaining a firm and
comfortable fit against the face at
all points.
4. Tighten the two bottom straps so
that the mask is snug against face.
The top two harness straps should
be flat against the top of the head.
5. If the mask does not feel snug
against the face, remove the mask
and adjust the length of the two
top straps. To adjust the top
straps:
a. Remove the strap from the fas-
tener button, by pulling the
loose end of the strap away
from the fastener button.
b. Move the slide away from the
lens ring to allow the strap to
slide through the lens ring con-
nection. Adjust the length of the
strap. Pull the straps to the next
hole. Secure the strap in posi-
tion by pulling the strap onto the
button.
c. Smooth the straps so that they
are flat. Move the slide so that it
is located at the lens ring con-
nection.
DONNING THE RESPIRATOR WITH
PLASTIC ADVANTAGE 3000 (MODEL
3100 SINGLE PORT) HARNESS
Instructions to Don the Mask
Note:
There are two recommended
donning procedures.
Donning Procedure A
1. Completely loosen the two bottom
straps. Spread the straps of the
head harness with both hands and
place chin into the mask. Pull har-
ness over head all the way, until
plastic cradle lies flat on back of
head.
2. Tighten neck straps evenly so that
the mask is snug against the face.
3. If necessary, adjust the mask and
tighten harness by pulling loop on
the back of harness.
Donning Procedure B
1. Completely loosen the two bottom
straps, insert fingers and hold the
loop on the back of the harness.
2. Place chin into the mask.
14
Visit: www.thesafetyequipmentstore.com Or Email: [email protected] for Sales & Service.
