MS 104/5
ML46758, Rev. 01
June 2002
Installation and Setup
Package Contents
•
MS 104/5
•
Power Cord
•
CD containing User Manual
Procedure
Install the MS 104/5 as follows:
1. Place the MS 104/5 on a flat stable surface (e.g., desk top).
2. Connect the MS 104/5 fiberoptic data ports
TX
and
RX
to the device(s),
ensuring that for each fiber, one end is connected to an RX port while the
other end is connected to a TX port as shown in Figure 5.
3. Interconnect the MS 104/5 electrical data ports and other devices.
Figure 5: Interconnection of MS 104/5 and another Device
4. With the aid of Table 1, set the DIP switch (on the front panel).
Note
If the device
port (to which t
he
MS 104/5
electrical data
port is
connected) does not have auto-negotiation capability, the
MS 104/5
port
operates in half-duplex mode and at the same speed of the device port.
5. Connect one end of the power cord to the MS 104/5 power port.
6. Connect the other end of the power cord to the ac line power (mains) to
power on the MS 104/5.
Note
If the DIP switch setting is changed while the MS 104/5 is powered on,
disconnect then reconnect the power cord to enable the MS 104/5 to
operate according to the new setting.
Operation
The MS 104/5 becomes fully operational within a few seconds after being
powered on.
Its operation can be monitored by interpreting the status of its LEDs with the aid
of Table 2. If there is a problem, use the chapter Troubleshooting to resolve it.
12
