MRMC Pan Bars, Быстрый старт, Страница: 13 / 24

Pan Bars Quick Start Guide
11
The keywords used in the above table are described below:

*NetworkBoards
: The number of network boards (nodes) in
the system. You need to increase this by one (1) to cater for the
new board in the Pan Bars mimic device.

*NodeProgram3
: For the node to which you assigned the
mimic (node 3 in this case), add a reference to the
.btl
file
that you want Flair to load into the mimic device on that node
when starting up. The
.btl
file is already supplied with Flair
so you don’t need to copy or download it from elsewhere.

*RICMimic
: If this is set to True, Flair will reserve ports 1-8 for
RT-14 mimic inputs, and so ports 9-12 are assigned to Pan
Bars. It is recommended that this is set to True.

*MimicBoard1
: Assigns each mimic board to an available
node. You need to specify a node that is not already used by
another board. In this example nodes 1 to 2 are already used by
other boards so
*MimicBoard1
is assigned to node
3
. There is
only one mimic device installed so
*MimicBoard2
is
commented out.
Remember to save the file after you have edited it.
3. On the Pan Bars, move the
BOOT MODE
switch to the Centre
( Flair mode ) position.
4. With the Windows PC running but with Flair not running, attach
the power cables to the Pan Bars, the head, and the RT-12 or RT-14
unit (if you are using one).
5. When the RT-12 or RT-14 unit has finished starting up (if you are
using one), start Flair by double-clicking on the Flair icon on the
Windows Desktop.
At this point, ignore any Flair error messages and Pan Bars LED
lights.
6. In the Flair menu, click on Setups > Network Setup .
7. In the pop-up, click on the Find button.
8. In the Find results, find the IP address of the Pan Bars
(
192.168.1.236 in this example), and copy it into the node that you
assigned to the Pan Bars mimic device ( Node 3 in this example):