7
Installation Instructions and Owner’s Manual
Universal Unvented Room Heater
Attaching to Wall Anchor:
This way allows you to attach mounting bracket to hollow
walls (wall areas between studs) or to solid walls (concrete
or masonry).
Decide which way best suits your needs. Either method will
provide a secure hold for the mounting bracket.
1. Tape mounting bracket to wall where heater will
be located. Make sure mounting bracket is level.
For wall stud mounting locate one end of the
mounting bracket over a wall stud.
WARNING: Maintain minimum clearances shown in figure
7. If you can, provide greater clearances from the floor
and joining wall.
2. Mark screw locations on wall (see figure 7).
3. Remove tape and mount bracket from wall.
A
djoining W
all
18” Min.
See clearance
specs on Pg 3
16” (Lg)
12-9/64” (Sm)
Mark mounting hole locations and
drill holes where indicated. Allow for
minimum clearances
Figure 7
Attaching to Wall Stud:
For attaching mounting bracket to wall studs
1.
Drill holes at marked locations using 9/64” drill bit.
2.
Place mounting bracket onto wall. Line up holes on
each end of bracket with hole drilled in wall.
3. Insert mounting screws through bracket and into
wall studs.
4. Tighten screws until mounting bracket is firmly
fastened to wall studs.
Attaching to Wall using Anchor:
For attaching mounting bracket to hollow walls (wall areas
between studs) or solid walls (concrete or masonry)
Note: Wall anchors, mounting screws, and spacer are in
hardware package. The hardware package is provided with
heater.
1.
Drill holes at marked locations using 5/16” drill bit.
For solid walls (concrete or masonry), drill at least 1”
deep.
2. Fold wall anchor as shown in figure 8 below.
3. Insert wall anchor (wings
first) into hole. Tap anchor
flush to wall.
4.
For thin walls (1/2” or less)
insert red key into wall
anchor.
5. Place mounting bracket onto wall. Line up holes on
each end of bracket with wall anchors.
6. Insert mounting screws through bracket and into
wall anchors.
7.
Tighten screws until mounting bracket is firmly
fastened to wall.
Placing Heater on Mounting Bracket
1. Locate two horizontal slots on back pane of heater
(see figure 9).
2.
Place heater onto mounting bracket. Slide horizontal
slots onto stand-out tabs on mounting bracket.
Horizontal Slots
Mounting Bracket
mounted to wall
Figure 9
Installing Bottom Mounting Screws
1. Locate two bottom mounting holes. These holes are
near bottom on back panel of heater (see figure 10).
Screw
hole
Screw
hole
Figure 10
2.
Mark screws locations on wall.
3. Remove heater from mounting bracket.
4. If installing bottom mounting screw into hollow
or solid wall, install wall anchors. Follow steps 1
through 4 under Attaching to Wall using Anchor. If
installing bottom mounting screw into wall stud, drill
holes at marked locations using 9/64” drill bit.
5.
Re-place heater onto mounting bracket.
6. Place spacers between bottom mounting holes and
wall anchor or drilled hole.
7.
Hold spacer in place with one hand. With the other
hand, insert mounting screw through bottom
mounting hole and spacer. Place tip of screw in
opening of wall anchor or drilled hole.
8.
Tighten both screws until heater is firmly secured to
wall. Do not over tighten.
Note: Do not re-place front panel at this time.
Replace front panel after making gas connections and
checking for leaks.
Figure 8.
