8
7. Move the loader attaching plate levers (A) to the
locked (fully down) position either manually or by
using the loader controls.
8. Park the loader. (See Parking Safely in this manual.)
Picture Note: Wedge on right side shown. Check the
wedges or pins on both sides of the attachment.
9. Check to be sure the loader attaching plate pins or
wedges (C) extended into the holes in the bottom
of the attachment mounting frame. If not, move the
loader attaching plate levers to the unlocked (up)
position and repeat installation.
IMPORTANT
AVOID DAMAGE!
The attachment may come off the loader if it is
not secured to the attaching plate. The attaching
plate pins or wedges must be extended into the
attachment with the levers fully down.
Preparing for Installation
1. Check the loader and attachment hydraulic couplers
to be sure the surfaces are clean before connecting.
2. Inspect the couplers for damage or wear and replace
if needed for proper connection.
Installing the Attachment
1. Follow the instructions in the loader operator’s
manual to install the attachment and exit the operator
station safely.
2. Fully lower the loader lift arms.
3. Move the loader attaching plate levers (A) to the
unlocked (up) position either manually or by using
the loader controls.
4. Tilt the loader attaching plate forward, and drive
the loader forward until the top edge of the loader
attaching plate is under the top flange (B) of the
attachment mounting frame.
5. Raise the loader lift arms slightly until the attaching
plate is fully seated under the top flange.
6. Tilt the attaching plate backward to raise the front of
the attachment.
IMPORTANT
AVOID DAMAGE!
Attaching plate levers may be damaged if they
strike the attachment. Be sure the attaching plate
levers do not hit the attachment during installation.
Installing and Removing
