MRC MCX-5000 Series, Руководство пользователя, Страница: 30 / 220

MARINE RADIO CO.,LTD.
주
/
선박무선
Subject : Auto Exchanger Page : (29 / 46)
Date : 2010.10.13 Doc. : MCX-5000S_ENG_R1
(QAS-ADD-008/1/10.10.13) manual\pabx\mcx-5000S\MCX-5000S_eng.doc
( MARINE RADIO CO., LTD.) MRC
1. Programming Guide
1.1 Program function.
1) Function of changing & editing extension number.
2) Function of changing dial
3) Function of setting ARS & making automatic connection to
outgoing call.
4) Function of setting "Group Call"
5) Function of setting "Priority Call"
6) Function of setting password.
1.2 Description of key board panel
1.2.1 Description of display panel
1) Display Window: It normally displays "time". And when
alarm occurs, it shows number corresponding
telephone that its handset isn't put down properly. If
handsets of several telephones are not put down
properly, their corresponding telephone number is
sequentially displayed.
2) RUN : If system is operating normally, Green LED is
continuously kept "ON"
3) POWER: It indicates that AC & DC power are supplied. (Green LCD)
4) Alarm: When alarm occurs, red LED is keep flashing and buzzer is activating.
5) Dial 10-Key pad: No Button 0
～
9: Button for inputting numbers when program is modified 1(A)
～
6(F) number button: If number button (1
～
6) is pressed after "shift key" button is pressed, they
would be recognized their corresponding Alphabet.
6) FUNC. Button : Go into function mode in order to modify programming
7) EXIT Button: Finish it up by pressing "EXIT Button" after completing to modify programming.
8) ENTER Button: Save it by pressing "ENTER Button" after program is finally completed and
modified.
9) BZ STOP: When you press this switch when alarm occurs, buzzer stops or lamp for alarm keep
flashing.
10) SYSTEM RESET
When error from "CPU" occurs due to specified factor, press this switch. And then system will be
recovered to normal condition. (Caution) When system is operating normally, busy line will be
disconnected.
1.3 Precaution for programming MCX-5000S
After system is installed, initially programming is needed as follows
1) Set DIAL DIGIT (2-digit or 3-digit number)
2) Set extension DIAL number.
※
Date & Time will be displayed in LCD panel as picture below
After power on, the date and time displays on the LCD window.
Standard window:
March 19, 2010 18:34:28
UT 2010 03 19
18:34:28