
* In delay mode, the correct delayed angle can only be obtained
with a stable input signal
When the input signal frequency exceeds the upper and lower limits,
the alarm mark will be flash displayed and the strobe will stop
flashing
4-4 Synchronous signal output
The synchronous signal is output from # 4 pin connector.
connect wire digram ref. Fig. 2
4- 5 Checking Motion
For motion analysis, simply locate the actual speed as mentioned
above and then turn the dial slowly up or down. This will give a
slow motion effect allowing complete inspection.
12
Содержание DT-2279
Страница 10: ...3 FRONT PANEL LAYOUT DESCRIPTION Fig 1 6...
Страница 18: ...6 THE ADDRESS OF AFTER SERVICE CENTER 14...