MRA 4025066169344, Инструкция по монтажу

Страница: 3 / 8

3
GB
MOUNTING INSTRUCTIONS
Kawasaki Z650 20-
Thank you for buying a MRA Windshield.
Read this manual carefully and check the parts list for completeness before you begin. We recommend
that you have your screen fitted by an authorised workshop.
Number Article Article
No.
Required tools
1 MRA screen --- Allen key 3, 4 mm
1 Pair of retaining plates 11431
4 Fillister head screw M5 x 25mm 10641
8 Plastic washers 12 x 5 x 0.5 mm 10635
4 Spacer sleeves, 6 mm 11038
4 Rubber nuts, M5 10629
4 O-rings, 4.5 x 1.5 mm 10992
4 Fillister head screws, black M5 x 16 mm 10554
1 Protective edge strip with clamping sleeves ---
Mounting the windscreen on the motorcycle:
1. Place the motorcycle on a flat surface.
2. Disassemble the original windscreen.
3. Take the retaining plates [11431] provided and insert the M5 x 25 mm fillister head screws [10641]
with the plastic washers [10635] through the retaining plate drill holes. Now, place the 6 mm
distance sleeves [11038] against these from behind and secure them with the O-rings [10992]. Then,
place the M5 rubber nuts [10629] on the retaining plates (P1).
4. Unscrew and remove the original retaining screws from the small original windscreen. Now, mount
the MRA retaining plates onto the original windscreen. Fully tighten the screws (P2). Our tip: first, fit
the retaining plate on one side, then fit the other side. If all original fastening screws are removed at
the same time, the original windscreen might fall.
5. Now, you can mount the MRA windscreen with the M5 x 16 fillister head screws [10554] and the
plastic washers [10635] onto the retaining plates and then tighten all screws.
6. Apply the protective edge strip profile as shown in figure 3. Cut off the rest if required.
7. Push the clamping sleeves over the ends of the protective edge strip profile and lightly press these
together using a pair of pliers to secure the protective edge strip profile.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
spirits to clean the screen as they will damage it.
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de