mr. steam AirTempo, Инструкция по установке, эксплуатации и обслуживанию, Страница: 8 / 11

mr
.
steam
Maintenance Instructions
________________________________________________________________________________________________
14
mr
.
steam
Maintenance Instructions
________________________________________________________________________________________________
15
Battery replacement
The batteries in AirTempo will need periodic replacement. Both batteries
should be replaced at the same time with new CR2450 coin cell batteries.
CHOKE HAZARD. The batteries and battery doors are small
pieces, keep out of reach of children.
KEEP BATTERIES OUT OF REACH OF CHILDREN.
Swallowing may lead to serious injury or death in as little as 2 hours due to
chemical burns and potential perforation of the esophagus. Immediately
see a doctor.
Remove the AirTempo from the wall by sliding it up and off the bayonet holder.
The AirTempo comes off the flush mount holder by grasping the bezel and pulling
the assembly straight out of the flush mount box.
Use a soft cloth to dry off the control.
With two fingers turn the battery doors in the direction noted. The left battery
cover is opened by turning it clockwise, the right cover is opened by turning it
counterclockwise.
Discard both batteries and replace with new batteries, the positive side of the
battery goes towards the “+” symbol on the battery door.
WarNiNG
!
WarNiNG
!
CaUtiON
!
System Status Codes
The AirTempo may display a status code if the steam system is not function-
ing correctly.
err C
indicates the AirTempo control has lost communication with the steam
generator. Ensure all connections are secure between the steam generator
and the transceiver
err p indicates an error while pairing, reset the control and redo pairing.
A complete list of steam generator status codes can be found in the MrSteam
Residential Steambath Installation Operation and Maintenance Manual.
pairing
AirTempos are factory paired, however if more than one steam system is
installed in close proximity the AirTempo controls must be paired to their
transceivers to prevent interference.
To pair AirTempo use a blunt object to press the button inside the transceiver
adjacent to the LED. Hold the button for 5 seconds, when the transceiver
is in pairing mode the LED will turn blink blue for 2 minutes.
While the transceiver LED is blinking, press and hold the button on
AirTempo for 5 seconds until the display reads PAIR.
Replace the battery door and lock in place.
To prevent water from getting in the control in-
gress, ensure the battery doors are in the locked position before
reinstalling control.
Care tips for airtempo Controls and Steamheads
1. Use only mild soap and water on a soft cloth to clean
the control and steamhead.
2. Do not use abrasive cleansers
3. If the decorative cover is damaged call MrSteam
technical service for replacement parts.
Warranty
To register your steam generator unit online and to review
the MrSteam Limited Lifetime Warranty please go to:
blog.mrsteam.com/wr