mr
.
steam
Installation Instructions
________________________________________________________________________________________________
9
mr
.
steam
Installation Instructions
________________________________________________________________________________________________
8
The Remote Temperature Probe is required when the AirTempo control is
installed outside the steam room.
The Remote Temperature Probe is for use with AirTempo,
iTempo and iTempoPlus controls only. Do not use with any other controls.
Do not use any other temperature probe with the AirTempo, iTempo and
iTempoPlus controls. Noncompatible products may result in an inoperative
control and a hazardous condition.
Install the AirTempo controls according to the installation
instructions on pages 4-7. Failure to do so may result in an inoperative
control and a hazardous condition.
1.
Determine the location of the Remote Temperature Probe:
The Remote Temperature Probe must be installed:
a.
On a vertical surface
b.
4-5 feet above the floor
c.
in a location representative of the desired steam bathing temperature.
Locating the MSTS near the steamhead or near direct steam emis-
sions may result in poor steam room temperature control.
d.
The probe has an integral 30’ cable. Insure that the probe and/or
steam generator are located accordingly.
2.
Drill a 5/16 inch diameter hole in the wall. Do not oversize or
under size the hole. Clean area thoroughly.
NOte:
The silicone supplied by MrSteam can be used to meet
a variety of sealing and gasketing. It cures to silicone rubber
and
adheres to glass, wood, metal, porcelain, ceramic tile, painted
surfaces, many plastics and rubber. Surfaces must be clean and
dry. Apply thin layer of product. Fit together and support if
necessary. Allow excess material to cure, then trim with a sharp
blade. Sealant “skins” in 5 minutes, dries to touch in 1 hour.
Fully cures and bonds in 24 hrs.
3.
Remove the knock-out from the steam generator jacket as
shown in Diagram 1.
4.
Insert the probe cable through the knock-out and connect to
the connector on the steam generator printed circuit board
marked EXT TEMP as shown in Diagram 1.
CaUtiON
!
CaUtiON
!
installing the remote temperature probe
(PN: MSTS)
Mr.Steam Steam Generator
(shown with cover removed
and NOT installed)
Temperature
Probe Cable
(30 feet)
Knock-Out
Temperature
Sensor Probe
Temperature
Probe Connection
DiaGram 1
Drawings for Illustrative Purposes Only.
Содержание AirTempo
Страница 10: ...18 19...