Assembly Manual Anita Big Digit Clock
Now attach carefully the display for the first function test (but fix it with one hand) and connect the
clock to a 5 V USB power supply.
The display should light up and start with the sequence 1 - 2- 3- 0.
If everything is okay, we can start with the enclosure
assembly:
First attach the two mounting brackets to the display
with a Torx M3 x 4 screw each.
Remove the protective film from the bottom plate and fix the four
15 mm spacers with four black Tx M3 x 8 screws.
Remove from all 6 mm transparent and 3 mm black
enclosure frames (9 pieces in total) the protective films.
- 1 - Please first assemble three of 6 mm transparent enclsoure
frames (light blue + light green), the engraved rear side (light
gray) as shown and insert four rosettes (orange) as PCB
spacers.
- 2 - Next insert the circuit board, fix it with four Tx M3 x 6 self-
tapping screws (light grey), next insert the small frame (light gray)
next to the pushbutton switches.
NTP
USB
SYNC
DST
ADJ
SEL
- 1 -
Assemble next carefully three
black 3 mm enclosure frames
(dark red and brown) and the
pushbotton cover (blue) with the
mirrored site up.
- 2 -
Fit next the pushbutton frame
(violett) and the remaining three
6 mm transparent enlcosure
frames.
Finally fix with the remaining four
Tx M3 x 8 screws the mirrored
top cover.
Now fit the four self athesive
bumpers on botton side.
