MQ Multiquip Mikasa MVH120, Руководство по обслуживанию

Страница: 18 / 33

Reassembling the driven shaft:
MVH-120 and 150
1. Insert 210
°
cam ring (7) to drive shaft (4).
Pay attention to the direction of flange face to
install. (See Fig.18)
Fig.21
Position of pressed-in
parallel pin.
Coat with molybdenum
grease.
Press-in
2. Insert two bearings 6807(9) to driven shaft
from its each end and retain them with stop
ring S-35 (5). Apply flat screw drive blade and
lightly tap on it to make sure that the stop ring
has seated in the groove properly. (See Fig.19)
Fig.18 Driven shaft side
Apply
molybdenum
grease
Shifter piston side.
Pay attention o direction t
of flange face.
Fig.19 Driven shaft
Driven shaft side
Apply molybdenum grease.
Fig.20
3. Insert piston rod (11) to the driven shaft (See
Fig.20).
4. Press the parallel pin (12) via cam ring into piston rod. After pressing it in, make sure that the
parallel pin does not protrude from periphery of the cam ring. (See Fig.21)
5. After inserting driven shaft gear (31) to cam ring
(7), lock it with four hex socket head bolts 6x20 (44).
Driven shaft gear (31) and cam ring should be
aligned with punch marks as shown in Fig.23.
Install Fig.22
Bolts should be coated with Loctite 271.
Tightening torque: 180kgf-cm
Fig.24
６Ｘ２０
Tightening torque:
180kgf-cm
Loctite 271
Fig.23
Mating punch mark on
driven shaft (31)
Mating punch mark on210
°
cam ring
15