MQ Multiquip Mikasa MT76D, Руководство по эксплуатации и запасным частям

Страница: 19 / 54

MT76D RAMMER • OPERATION AND PARTS MANUAL — REV. #7 (07/14/16) — PAGE 19
MAINTENANCE
4. Clean foam element (Figure 17) in warm, soapy water
or non-flammable solvent. Rinse and dry thoroughly.
5. Next, dip the element in clean engine oil and completely
squeeze out the excess oil from the element before
installing.
Figure 17. Cleaning Foam Element
Paper Air Filter Element
1. Check the paper element daily or before starting the
engine
2. Check for and correct heavy buildup of dirt and debris
along with loose or damaged components.
3. To clean the paper air filter element as referenced in
(Figure 18), tap the filter element several times on a
hard surface to remove dirt, or blow compressed air
(not to exceed 30 psi (207 kPa, 2.1 kgf/cm
2
) through
the filter element from the inside out.
SOLVENT
ENGINE OIL
FOAM
ELEMENT
SQUEEZE
THOROUGHLY
CAUTION
Wear protective equipment such as
approved safety glasses or face shields
and dust masks or respirators when
cleaning air filters with compressed air.
NOTICE
DO NOT use excessive air pressure or the paper
air filter element will be damaged and will need to be
replaced.
Figure 18. Cleaning Paper Element
TRANSPORTATION
Maintain upright position of rammer at all times. Transport
rammer in upright position. If rammer must be laid down
for transportation, drain the diesel fuel first and lay rammer
with muffler side down (Figure 19).
Figure 19. Transporting Rammer
The fuel filter is installed at the bottom of fuel tank. Should
the rammer be laid on its side, dirt from the fuel filter may
contaminate the injection nozzle, causing damage to the
fuel pump.
PAPER
ELEMENT
BLOW COMPRESSED
AIR FROM THE
INSIDE OUT