MPM MZE-17, Руководство пользователя

Страница: 13 / 40

3.
Open the water fill lid
11
.
4.
Fill the iron water tank
8
from the measuring cup up to the MAX level. Check the max level
in the tank by putting the iron straight up.
CAUTION! Do not overfill the water tank above the MAX level. Always use fresh demineralised/distilled water
for best ironing performance. Never use chemically decalcified water or any other liquids.
5.
Close the water fill lid
11
.
USING THE APPLIANCE
TEMPERATURE SETTING
1.
Plug the power cord
6
to a PE mains outlet. The green indicator
7
will turn on.
2.
Put the iron standing up and set the required ironing temperature by turning the tempera-
ture control knob
5
to the desired position. The indicator
7
will switch to red to indicate
that the appliance is heating up.
TEMP KNOB POSITION THERMOSTAT ADJUSTMENT TEXTILE TYPE
•
Low temperature Synthetic fibres
• •
Moderate temperature Silk / wool
• • • / M a x
High temperature Cotton / linen
CAUTION! Check the required ironing temperature of your textile product by referring to its information tab.
If you are unsure what fabric type the product to be ironed is, find the correct temperature setting by ironing
the part of the product that will be concealed when in use/worn. Start from the lowest temperature setting
and increase it gradually. Silk, cotton and synthetics: to prevent glossy spots from heat, iron these materials
inside out and covered with another thin fabric. Do not use the spray jet to avoid stains while ironing. Velvet
and similar materials must be ironed in one direction only. Do not hold the iron in one spot, make full passes.
Iron synthetics and silk inside out and without steam.
CAUTION! Always start ironing with the products that require the lowest temperature setting.
3.
When the iron reaches the preset temperature and the indicator
7
switches to green, wait a
few seconds and start ironing.
4.
The indicator
7
changes colour (between green and red) during ironing.
NOTE! Your iron has the AUTO SHUT OFF function – an electronic device allowing to shut the iron off safely when
it is not used for some time. This protection will work regardless of the position of the iron (horizontal or verti-
cal). This function is indicated by sound and green flashing
7
.
STEAM IRONING
1.
Make sure that the water tank
8
has enough water.
2.
Set the recommended temperature (see TEMPERATURE SETTING).
3.
Set the correct steam output with the control slider
1
.
CAUTION! Steam ironing is only possible at higher temperatures (temperature settings from •• up to MAX level).
13
GB