MPM MMW-02, Руководство пользователя

Страница: 19 / 52

19
EN
USE OF OIL
 In order to ensure that the hair clipper is sharp,
the blades should be oiled every few cuts – see
Figure 3.

Do not use hair oils, grease, oils mixed with kero-
sene or solvent, because the solvent will evapo-
rate and the thick oil will remain and slow down
the movement of blades
LEVER FOR ADJUSTING BLADES
1.
The lever is located near the thumb (right-handed person) and
it can be used comfortably while holding the hair clipper in your
hand.
2.
Thanks to the lever, the hair clipper is more versatile and allows
you to gradually change the length of the cut – without using the
comb.
3.
When the lever is in the highest position, blades will cut in closest
position to the skin and the remaining hair will be very short. By
moving the lever down, you can gradually increase the length of
hair.
4.
In the lowest position, the hair will have (approximately) the length
close to the use of the 3mm attachment.
5.
The lever also increases the range of the blades’
use, because the cutting angle is different in
each setting – see Figure 4.
6.
Additionally, if the blades become jammed dur-
ing an extremely heavy cutting, the lever will
enable to remove hair wedged between blades
without the need to remove these blades.
7.
Quickly move the lever from the minimum to the maximum posi-
tion (several times) after each cut. This will enable to clean blades
Figure 3
Figure 4