MPL PIP19, Техническое справочное руководство

Страница: 39 / 56

3.5.2.16 Firewire Header Connector (J14)
Used for MPL AGs Firewire Expansion Module (Firewire-Kit1).
Pin Signal Signal Description Pin Assignment
1 TPB- Twisted Pair B (Minus)
2 TPB+ Twisted Pair B (Plus)
3 GND Ground
4 TPA- Twisted Pair A (Minus)
5 TPA+ Twisted Pair A (Plus)
6 GND Ground
7 TPA(R) Twisted Pair A (Reference Ground)
8 V
P
9 V
P
Power is equivalent to VIN on J4 (please refer
to chapter 3.5.2.11 for more information)
10 GND Ground
2
10
1
9
Figure 43: Firewire Header Connector (Samtec,
EHT-105-01-S-D-SMLC)
3.5.2.17 Reset & Power Button Connector (J7)
Used for internal power- and reset button connection.
Pin Signal Signal Description Pin Assignment
1 PWRBTN# Power Button
2 RSTBTN# Reset Button
3 GND Ground
4 GND Ground
3
1
4
2
Figure 44: Reset & Power Button Connector
(Samtec, IPL1-102-02-S-D)
3.5.2.18 CAN Expansion Connector (J35)
This connector is reserved for future MPL system expansions.
Pin Signal Signal Description Pin Assignment
1 +5V 5 V System Power
2 GND Ground
3 SD0 ISA Bus Data Signal 0
4 SD1 ISA Bus Data Signal 1
5 SD2 ISA Bus Data Signal 2
6 SD3 ISA Bus Data Signal 3
7 SD4 ISA Bus Data Signal 4
8 SD5 ISA Bus Data Signal 5
9 SD6 ISA Bus Data Signal 6
10 SD7 ISA Bus Data Signal 7
11 SA0 ISA Bus Address Signal 0
12 SA1 ISA Bus Address Signal 1
13 SA2 ISA Bus Address Signal 2
14 SA3 ISA Bus Address Signal 3
15 SA4 ISA Bus Address Signal 4
16 SA5 ISA Bus Address Signal 5
17 SA6 ISA Bus Address Signal 6
18 SA7 ISA Bus Address Signal 7
19 R/Wn Read (High) / Write (Low Active) Signal
20 CSn Chip Select (Low Active)
21 RSTn Reset (Low Active)
22 CLK 16 MHz Clock
23 IRQn Interrupt (Low Active)
24 DSACKn Data Strobe Acknowledge
25 NC Not connected
26 NC Not connected
1
25
2
26
Figure 45: CAN Expansion Connector (Samtec,
TMM113-01-LD)

2012 by MPL AG 39 MEH-10126-201 Rev. F
High-Tech • Made in Switzerland
PIP19 / PIP20 / PIP22 / PIP23
Technical Reference Manual