Moza CRP, Руководство пользователя

Страница: 3 / 4

4 5
Pedal Surface Angle Adjustment
Use a hexagon screwdriver counterclockwise to loosen the screw on the face of the pedal.
Use your hand to turn the nut to change the angle of the pedal. To lock in the pedal’s position just
secure the screw on the face of the pedal. The pedal adjustment methods for accelerator, brake, and
clutch are the same.
Twist the adjusting nut to change the Accelerator stroke.
Rotate the adjusting nut on the upper part of the spring by hand. Moving downward will shorten
the throttle stroke. Accordingly, the starting force of the throttle will increase, and the ending force
will remain unchanged.
Accelerator Force and Stroke Adjustment
Brake Force Adjustment
1. Change the spring to adjust braking force
Loosen the screw with the M5 wrench, take out the screw and pin shaft, turn counterclock-wise,
and take out the spring assembly. Turn counterclockwise the flat nut and remove the spring assembly
to push out the spring and shaft, depress the spring. Then turn the flat nut clockwise to unscrew.
Swap in the different spring, screw back on the caps. The spring sleeve should be flush with the
monting hole, insert the pin and, tighten the screw.
2. Replace the damping block and change braking force
Remove the two screws on the side with the M5 wrench. Turn the decorative cover plate downward,
take out the pressure sensor fixing plate, take out the rubber pad, replace the corresponding rubber
pad. Then reassemble.
3. Adjust the brake mounting position to change braking force.