- 11 -
DIN-Rail Mounting
The aluminum DIN-Rail attachment plate should already be attached to
the back panel of the VPort 364 when you take it out of the box. If you
need to reattach the DIN-Rail attachment plate to the VPort 364, make
sure the stiff metal spring is situated towards the top, as shown in the
figures below.
STEP 1:
Insert the top of the
DIN-Rail into the slot just below
the stiff metal spring.
STEP 2:
The DIN-Rail attachment
unit will snap into place as shown
below.
To remove the VPort 364 from the DIN-Rail, simply reverse Steps 1 and 2
above.
Wall Mounting (optional)
For some applications, you will find it convenient to mount the VPort 364
on a wall, as illustrated below.
STEP 1:
Remove the aluminum DIN-Rail attachment plate from VPort 364, and
then attach the wall mount plates, as shown in the diagrams below.
STEP 2:
Mounting VPort 364 on the wall requires 4 screws. Use the
VPort 364, with wall mount plates attached, as a guide to
mark the correct locations of the 4 screws. The heads of
the screws should be less than 6.0 mm in diameter, and
the shafts should be less than 3.5 mm in diameter, as
shown in the figure at the right.
Do not screw the screws in all the way—leave a space of
about 2 mm to allow room for sliding the wall mount panel
between the wall and the screws.
