UC-7400-LX Plus User’s Manual
Programmer’s Guide
5-10
1.
Function: MOXA_SET_OP_MODE
int ioctl(fd, MOXA_SET_OP_MODE, &mode)
Description
Set the interface mode. Argument 3 mode will pass to the UART device driver and change it.
2.
Function: MOXA_GET_OP_MODE
int ioctl(fd, MOXA_GET_OP_MODE, &mode)
Description
Get the interface mode. Argument 3 mode will return the interface mode.
There are two Moxa private ioctl commands for setting up special baudrates.
Function: MOXA_SET_SPECIAL_BAUD_RATE
Function: MOXA_GET_SPECIAL_BAUD_RATE
If you use this ioctl to set a special baudrate, the termios cflag will be B4000000, in which case the
B4000000 define will be different. If the baudrate you get from termios (or from calling tcgetattr())
is B4000000, you must call ioctl with MOXA_GET_SPECIAL_BAUD_RATE to get the actual
baudrate.
Example for setting the baudrate
#include <moxadevice.h>
#include <termios.h>
struct termios term;
int fd, speed;
fd = open(“/dev/ttyM0”, O_RDWR);
tcgetattr(fd, &term);
term. c_cflag &= ~(CBAUD | CBAUDEX);
term.c_cflag |= B4000000;
tcsetattr(fd, TCSANOW, &term);
speed = 500000;
ioctl(fd, MOXA_SET_SPECIAL_BAUD_RATE, &speed);
Example for getting the baudrate
#include <moxadevice.h>
#include <termios.h>
struct termios term;
int fd, speed;
fd = open(“/dev/ttyM0”, O_RDWR);
tcgetattr(fd, &term);
if ( (term.c_cflag & (CBAUD|CBAUDEX)) != B4000000 ) {
// follow the standard termios baudrate define
} else {
ioctl(fd, MOXA_GET_SPECIAL_BAUD_RATE, &speed);
}
Baudrate inaccuracy
Divisor = 921600/Target Baudrate. (Only Integer part)
ENUM = 8 * (921600/Target - Divisor) ( Round up or down)
Inaccuracy = ( (Target Baud Rate – 921600/(D (ENUM/8))) / Target Baud Rate )* 100%
E.g.,
To calculate 500000 bps
Divisor = 1, ENUM = 7,
Inaccuracy = 1.7%
*The Inaccuracy should less than 2% for work reliably.
