NOTE Before tightening the screws into the wall, make sure the screw
head and shaft size are sui
one of the keyhole-shaped
table by inserting the screw through
apertures of the ToughNet sw
itch.
STEP 3:
Once the screws are fixed in the wall, hang the ToughNet switch on the 4
screws through the large opening of the keyhole-shaped apertures, and
then slide the switch downwards. Tighten the four screws for added
stability.
NOTE To provide greater protection from vibrations and shocks, use
screws with shaft diameter between 6.0 mm and 7.0 mm, and fix
the ToughNet switch onto the wall directly through the large
opening of the keyhole-shaped apertures.
DIN-Rail Mounting (optional)
With the optional DIN-Rail
mounting kit DK-DC50131 (must be
purchased separately), you can
mount the TN-5516/5518 on a
35mm DIN-Rail.
Use 12 screws (6 screws per plate)
STEP 1:
to atta
ail
attach
e rear pane
of the
ch the two DIN-R
ment plates to th
l
Recessed button
switch.
Spring-loaded bracket
STEP
If the s
n
to rele
e
spring
down a few millimeters in each
directio
2:
pring-loaded bracket is locked in place, push the recessed butto
ase it. Once released, you should feel some resistance from th
as you slide the bracket up and
n.
- 9 -
