- 5 -
DIN-Rail Mounting
The aluminum DIN-Rail attachment plate should already be fixed to the
back panel of the EDS-510A when you take it out of the box. If you need
to reattach the DIN-Rail attachment plate to the EDS-510A, make sure
the stiff metal spring is situated towards the top, as shown by the
following figures.
STEP 1
—
Insert the top of the
DIN-Rail into the slot just below the
stiff metal spring.
STEP 2
—
The DIN-Rail attachment
unit will snap into place as shown in
the following illustration.
To remove the EDS-510A from the DIN-Rail, simply reverse Steps 1 and
2 above.
Wall Mounting (Optional)
For some applications, you will find it convenient to mount Moxa
EDS-510A on the wall, as shown in the following illustrations:
STEP 1
—Remove the
aluminum DIN-Rail
attachment plate from the
rear panel of the EDS-510A,
and then attach the wall
mount plates with M3
screws, as shown in the
figure at the right.
STEP 2
—Mounting the EDS-510A on the wall requires
4 screws. Use the EDS-510A, with wall mount plates
attached, as a guide to mark the correct locations of
the 4 screws. The heads of the screws should be less
than 6.0 mm in diameter, and the shafts should be less
than 3.5 mm in diameter, as shown in the figure on at
right.
NOTE
Before tightening the screws into the wall, make sure the screw
head and shank size are suitable by inserting the screw through
one of the keyhole-shaped apertures of the Wall Mounting Plates.
Do not screw the screws in all the way—leave about 2 mm to allow room
for sliding the wall mount panel between the wall and the screws.