- 6 -
Wall Mounting (optional)
For transportation applications that require an EN50155 certification
report, you should purchase the optional wall mount for the AWK-5232,
since the wall mount has passed EN50155 testing. The wall mount is also
convenient for other applications that require mounting the AWK-5232 to
a wall.
STEP 1:
Remove the aluminum
DIN-Rail attachment plate
from the AWK-5232, and
then attach the wall mount
plates with M3 screws, as
shown in the adjacent
diagrams.
STEP 2:
Mounting the AWK-5232 to a wall requires 4 screws.
Use the AWK-5232 device, with wall mount plates
attached, as a guide to mark the correct locations of
the 4 screws. The heads of the screws should be less
than 6.0 mm in diameter, and the shafts should be less
than 3.5 mm in diameter, as shown in the figure at the
right.
Do not screw the screws in all the way—leave a space of about 2 mm to
allow room for sliding the wall mount panel between the wall and the
screws.
STEP 3:
Once the screws are fixed into
the wall, insert the four screw
heads through the large
opening of the
keyhole-shaped apertures,
and then slide the AWK-5232
downwards, as indicated to
the right. Tighten the four
screws for added stability.
WARNING
•
This equipment is intended to be used in a Restricted Access
Location, such as a dedicated computer room. Access can
only be gained by SERVICE PERSONS or by USERS who have
been instructed about the fact that the metal chassis of the
equipment is extremely hot and may cause burns.
•
Service persons or users have to pay special attention and
take special precaution before handling the equipment.
•
Access is to be controlled through the use of a lock and key or
a security identity system, controlled by the authority
responsible for the location. Only authorized, well-trained
professionals are allowed to access the restricted access
location.
•
External metal parts are hot!! Pay special attention or use
special protection before handling..
www.ipc2u.ru
www.moxa.pro
